A uni-coloured plastic surfacing material...
Telon is a uni-coloured plastic surfacing material used as a wall covering in laboratories and clean spaces, as well as a surfacing for doors, pillars, window ledges, furnishings and walls. The thickness of the material is 1.5 mm.
Required fields are followed by *.
Item of interest: (600), Telon
Enter in the measurements of your room
Code: 600
Pisara 150 is a plastic wall covering for wet areas in homes and public spaces, social rooms, change rooms, etc.
The moisture-resistant Pisara wall is hygienic and easy to maintain. Pisara is easy and fast to install as no separate waterproofing is required; Pisara provides an instantly watertight surface.
Pisara's subdued colour selection, and single-colour and small-dotted patterns, are suitable for a broad range of interiors. The surface is enlivened by light embossing.
Protective coating on e.g. doors, pillars, furniture and walls
Product | Telon, Laminated vinyl coating | ||||
Application | |||||
Thickness | EN 428 | 1,5 mm | |||
Weight | EN 430 | 2,400 g/m2 | |||
Width | EN 426 | 150 cm | |||
Product properties |
|||||
Property | Test method | Result | |||
Fire resistance | EN 13501-1 | D-s3-d0 | |||
Emissions |
|
||||
Residual indentation | EN 433 | < 0,1 mm | |||
Dimensional stability | EN 434 | < 0,4 % (EN 434) | |||
Tensile strength of welding seam | EN 684 | ≥ 240 N/50 mm | |||
Colour fastness | EN 105-B02 | ≥7 | |||
Flexibility | EN 435 | no cracking | |||
Resistance to chemicals |
Test period 24 hours and 2 hours (EN 423), after which the chemical was washed off.
|
Installation
The covering is fixed with dispersion adhesive. Please turn to the adhesive ma nu facturer if you have any questions about the adhesives.
The lengths of the covering are glued in a tight butt joint. Butt joints are welded with a welding rod. Also overlapping (2-4 cm) seams can be used. Overlapping is secured with a suitable cold welding fluid. A pencil cove should be done on outer corners to secure the installation. Installation temperature should be over +18 °C.
MAINTENANCE
Initial cleaning
Wash with alkaline detergent solution. Do not use abrasive cleaning implements. Dry the surface carefully after washing.
Initial polishing
Initial polishing is not necessary.
Daily maintenance
Damp or wet clean with a mild alkaline detergent solution, depending on type of soiling. The use of care maintenance agents also recommended.
Stain removal
All stains must be removed immediately to avoid permanent marks.
Warning
Stain remover may affect the covering or the adhesive. When in doubt about the effect of stain remover carry out a test or contact the product manufacturer.