LHT, a completely new from Toli Corporation. LHT combines the advantages of ceramic tiles and vinyl tiles together. Use on floor and walls. Made in Japan
Completely new floor covering as tough as ceramic tiles and flexibility of vinyl tiles.
Luxury Hard Tile “LHT” is a new concept of vinyl tile created by TOLI’s technical capabilities and frontier spirit. As tough as ceramic tiles with the flexibility of vinyl tiles.
Highly durable stain resistance. Beautiful finish by concealing the imperfect subfloor. Can be installed over existing hard floor coverings. (discuss with ECOFLOORS expert)
Despite the same thickness and weight as existing vinyl floor tiles, higher functions have been added. Durable, lightweight, and beautiful - that’s LHT (Luxury Hard Tile), ToughtecTile.
Not being affected by the imperfect subfloor, “LHT” is Low-maintenance, durable, and easier to install compared to ceramic tiles.
Packaging:
Before installation, make sure the arrow marks on the back of each tile, which show the direction of the pattern.
For one week after installation, direct sunlight, sudden change of temperature due to air conditioning, and water washing should be avoided.
The colour shading differs on a tile-by-tile basis, which will make the floor look very natural when the tiles are installed.
In case the sub-floor is not even, the tiles may not be firmly installed on it. Please check whether the sub-floor is flat and smooth in advance. If you find uneven parts, repair, and make it flat before installation.
For TOUGHTECHTILE, install the tiles a bit loosely, with a very slight gap between the tiles. In case they are installed tightly with no gap at all, the tiles might be swelled and popped up on the joints due to changes of temperature.
If you install TOUGHTECTILE on the top of existing ceramic tiles or vinyl tiles, their surface should be properly prepared in advance. For installation, use a moisture-resistant adhesive.
TOUGHTECTILE may take more time to be cut compared to existing vinyl tiles. Based upon a set time of the adhesive, plan the time frame for cutting and installation at the site.
No need to apply the maintenance wax on the surface. Clean the floor every day with an auto scrubber or a wet rag wrung out tightly. Use the neutral detergent for fixed contamination. The dirt on the bevelled part should be cleaned along its direction.
High speed buffing should be avoided. Otherwise highly durable UV coating will be abraded.
NW-EX Series is made to repel the wax coating. For wax application, the designated surface treatment should be prepared in advance.
At the entrance of the building, the dust control mat should be laid to avoid soils and sands from outside.
Please be aware that some rubber casters might cause colour-contamination.
Please note that the product has the indigenous odour from its materials.
